![]() If it is separate from the bound volume it must be clearly labelled with the same information as on the title page. If you wish to submit material in any other form, your supervisor must contact Research Degrees well in advance of submission of the thesis.Īny material which cannot be bound in with the text must be placed either in a pocket inside or attached to the back cover or in a rigid container similar in format to the bound thesis. Illustrative material may be submitted on a CD-ROM. In each copy of the thesis the abstract should be followed by a full table of contents (including any material not bound in) and a list of tables, photographs and any other materials. It is good practice to use bookmarking within the PDF of the thesis in electronic form to allow readers to jump to the relevant section, figure, table etc. The form, and information about how to complete it is available on the Doctoral School’s website.įind out more about the UCL Research Paper Declaration Form Table of contents ![]() in a journal) previously, then you will need to insert a completed copy of the UCL Research Paper Declaration Form into your thesis after the Impact Statement. If you have included any work in your thesis that you have published (e.g. For further information on the content of the Impact Statement, please see the Impact Statement Guidance Notes for Research Students and Supervisors on the Doctoral School's website.įind out more about the Impact Statement Inclusion of published works in doctoral theses The abstract should be followed by an impact statement consisting of no more than 500 words. The signed declaration should be followed by an abstract consisting of no more than 300 words. Please see the section below entitled ‘Inclusion of published works in doctoral theses’ for more information about how to indicate when you have re-used material that you have previously published. Where information has been derived from other sources, I confirm that this has been indicated in the thesis.' ‘I, confirm that the work presented in this thesis is my own. The title page should be followed by a signed declaration that the work presented in the thesis is the candidate’s own e.g. the degree for which the thesis is submitted.the officially-approved title of the thesis.Any material which cannot be bound in with the text must be placed in a pocket inside or attached to the back cover or in a rigid container similar in format to the bound thesis (see Illustrative material). This sequence must include everything bound in the volume, including maps, diagrams, blank pages, etc. from the title page of the first volume to the last page of type, in Arabic numerals from 1 onwards. PaginationĪll pages must be numbered in one continuous sequence, i.e. Double or one-and-a-half spacing should be used in typescripts, except for indented quotations or footnotes where single spacing may be used. Margins at the binding edge must not be less than 40 mm (1.5 inches) and other margins not less than 20 mm (.75 inches). Plain white paper must be used, of good quality and of sufficient opacity for normal reading. PaperĪ4 size paper (210 x 297 mm) should be used. Illustrations should be permanently mounted on A4 size paper and bound in with the thesis you may not use sellotape or similar materials. If printed, please present your thesis in a permanent and legible format. We would recommend using Arial or Helvetica fonts, at a size of no less than 12.įind out more about the accessibility guidelines In the electronic version of your thesis, hyperlinks (including DOIs) should be functional and resolve to the correct webpage.
0 Comments
Leave a Reply. |